Performance and Features? High temperature resistance, the highest temperature up to 1300 ℃? High adhesion, combined with metal and refractory strong? Heat airflow and dust erosion, long life? Ultra-low thermal conductivity, good insulation effect? ??Coating room temperature curing, non-toxic, green? facilitate construction. Technical indicators thermal conductivity of 0.05 W / mK Ph value 7-8 working temperature ~ 1300 ℃ density of 0.5 ~ 1.0g / cm3 Viscosity 2 ~ 4Pa. S compressive strength 2 ~ 5MPa Applications This product has excellent insulation properties can be widely used in various high temperature industrial furnaces, high temperature steam pipes, heat exchangers, condensers, metallurgical industry, metal protection, high temperature, the product Application of the inner wall of the furnace lining is not only energy, but also can slow stream erosion, acid atmosphere furnace wall erosion and thus increase the service life of the lining, such as brushing the fiber lining Face powder we can solve the problem of fibers, on the other hand improve alkali vapor corrosion fiber lining to improve its use life. Instructions 1. Clean by brushing the surface, remove dust and debris material surface. 2, the construction of thermal insulation coatings available spray, brush or roll coating methods, such as the choice of brush or roller coating method, brush or roller picks up the available portion of the coating solution, brush or roller on the material surface, paint a brush or roller coating thickness up to 0.1 ~ 0.5mm thickness, after a construction until dry before a second construction until the target thickness, the total thickness of the coating should generally not exceed 5cm. 3. The selection of spraying, the initial spray coating thickness less than 0.1mm, secondary painting needed to be dry after the last spraying table sequentially repeated until the target thickness. 4, if the substrate allows, in order to save construction time, after each layer coated finish can dry 1-2 hours at below 60 ℃ oven, and then coated with a coating under. 5, brushing the surface temperature of an object or device is the best 10 ~ 30 ℃, can not be directly applied to the low running hot surface, brushing the ambient temperature is above 5 ℃, dry place construction. 6, after coating the coating to be placed in the air is dry and then baked at a temperature of about 100 ℃ for 12 hours until the coating of hard work, the furnace temperature to the normal stage. 7, the metallized surface must be pre-treatment can be carried out to ensure a certain roughness spray insulation coatings. Notes This product must be sealed in the environment of 5 ~ 30 ℃, avoid strong sunlight. Before using this product if settlement Stir well before using. The product packaging coatings: 10kg / barrel, 25kg / barrel, 200kg / barrel The product shelf life of 12 months.